Thread: Interior light kit

Originally Posted by Codefox

Did you pull out your fuses before you did this? Sounds to me like you blew your master fuse. Casey did the same thing.

Yeah, I did the same thing. There's a spare in the driver's side hood fusebox.
It's the 10A fuse. Blew mine while installing the trunk lighting.

^ yeah thats how I blew my first fuse too the OEM bulb was a pain to get out.

If you take the whole console out, buy some blue loctite and put it on the threads of the screws when it all goes back together otherwise it'll slowly creep out and start squeaking.

Originally Posted by Vidfreaky

I got the same kit for Christmas. I got the interior dome lights in (had to reverse the polarity on one, thanks for the tip) and the trunk in, but couldn't get the covers off the others.

Any tips as to how the vanity lights, glove box light covers come off? I got the license plate light box out, but it's still sealed when you pop it out, how do you get at the lamp?

You have to twist the bottom for the light to come out of the casing (like the dome lights). The vanity lights you use a flathead on the right hand side of the light. There's a clip you push in and then you just pull it down to pop it off. That's how I recall doing it.

where did you get your led dome lights?

Originally Posted by Moose

where did you get your led dome lights?

G) check vendors for D D lights (diode dynamics)

yeah Paul at DD has great kits, high quality bulbs and is really easy to deal with (even if he doesn't answer his phone :P)

Finally got mine installed, was easier than I thought. How to change the bulbs is on page 7/59 of the manual. Got all of them done, doing the last vanity and I blew a fuse, I checked all of them and can't find which one. is it on the side or under the hood?

it's most likely the one in the driver compartment fuse panel under the yellow clip, there are two fuses there one is a "Master" fuse for pretty much everything.